Non glossy, non glazing and non yellowing water based floor lacquer
It will fully penetrate the wood floor and it will maintain the natural look
Incredibly durable, fume free, high solid levels and unaffected by UV
Suitable for sealing and protecting very high traffic commercial floors
A two pack floor lacquer compatible with all oil and water based stains
It will cover at least 12 sq meters per 1L and it will dry within a few min
To be applied with a clean varnishing roller over a sealant free surface
It can be used to seal and protect wood floors, wood furniture, worktops
If you are looking for a 100% natural finish then do not prime the surface
One of the most durable water based floor lacquers ever manufactured
Chimiver Ecostar 2K Natural | Why Use It
For those looking for a finish similar to a floor oil but without the regular maintenance required by oiled floors, Chimiver has created the new Chimiver Ecostar 2K Natural. This product is unique and in a class of its own. 37% solid content (the highest level of solid content ever), 100% natural looking, suitable for very high commercial traffic, easy to apply, non yellowing over time and with a superior coverage area, it would be mad not to consider this product if you are on the market for a super high traffic water based floor lacquer with a natural finish. The product is also food certified so it can be used to seal and protect wood toys and wood worktops.
Chimiver Ecostar 2K Natural | Where To Use It
The unequalled Chimiver Ecostar 2K Natural is a professional quality water based floor lacquer compatible with all high traffic wood floors, all interior wood furniture, wood frames, wood doors, wood toys and all other wood surfaces. It can be used indoors only. Companies all over the world use Chimiver Ecostar 2K Natural to seal and protect antique furniture and very rare and precious wood items. The product is fume free so it can be used even in areas with little or no ventilation. Also suitable for sealing and protecting residential hardwood floors.
Chimiver Ecostar 2K Natural | How To Use It
You have purchased a natural looking high traffic water based floor lacquer because you are looking for a natural finish. To obtain that, you will need to make sure that the wood surface is sealant free, clean and finished with 100 grit sandpaper. Even brand new wood floors that were not sealed before will require a fine sanding before applying the product. Do not use a primer or a stain if you are looking for a non glazed and non “artificial” looking finish.
The surface has to be sanded and all pre-existing finishes removed. The final sanding should be done with 100 grit sanding paper. Do not sand against the fiber of the wood
Vacuum the whole floor a number of times until even the finest grain of dust is extracted. Use a flat microfiber mop head to remove even more dust.
Mix up the lacquer with the hardener while mixing up the composition. You will have to use the mixture within 2 hours otherwise it will get hard.
Using a soft varnishing brush, varnish all the edges and all the areas where the varnishing roller cannot fit. Apply a generous amount of lacquer while rolling the varnishing roller up and down along with the fiber of the wood. The surface has to look wet but not over-wet.
Allow it to dry for up to 2 hours (depending on the ventilation)
Re-sand the whole surface with 150-180 grit sandpaper to remove all the imperfections from the surface
Apply the last coat of floor lacquer and do not walk on the floor for at least 5 hours. The curing time is anything between 12 to 24 hours.
Chimiver Ecostar 2K Natural | Recommendation
Make sure to mix up the floor lacquer with the hardener and also make sure to use the composition within 2 hours. Do not apply the product over pre-existing finishes. Do not walk on the surface while wet. Do not sand up the floor between the coats unless the floor is fully dry. Do not apply more than 2 coats. Wash all your tools and rollers as soon as you are done with it. Store the product in a cool and dry place.