No fumes, no bad odours and known to last for many years
Junckers Refresher - Where to use
Wooden floors can become dull and patchy for a number of reasons. In many cases the UV light will discolor the floors or harsh chemicals will dull the top coat. The floor still has full protection but the sheen is not even and the whole area looks cheap. You restore the original look of your floor with 1-2 coats of Junckers Refresher. This product will glaze the surface of your floor, it will level all colour imperfections and it will mask dull patches. The floor will look clean and radiant again. No special training is required to use the product. 1 coat will do the trick in most cases but two coats can be better in some extreme cases. You can use the product on all types of wood floors that were sealed with a water based or solvent based floor lacquer or on floors that were sealed with a polish. Not suitable for oiled/waxed wooden floors.
Junckers Refresher - How to use
Wash the floor as usual with a flat mop and Junckers Sylvaclean. Allow about 30 min to fully well and prepare for polishing. You will need a flat mop, a quality microfiber mop head and the refresher. Apply 1 thin coat of Junckers Refresher going along the fibre of the wood. Do not over soak the floor and apply the same quantity of refresher all over the floor. If a second coat is required, you can apply it after about 1 hour. Job done.
By using Junckers Refresher you will increase the periods between floor refinishing, the floors will be easier to maintain and you will have healthier looking wooden floors for longer. Restore your old and worn wooden floors with Junckers Refresher