-anthracite grey is a dark tone of grey wood stain
-suitable to use on floors and all types of wood surfaces
-to be applied on new or newly sanded surfaces only
-coatable with any of Junckers water based lacquers
-unique look, premium coverage, fast drying, rich
-it will cover around 50 sq meter per L of wood stain
Junckers Anthracite Grey Wood Stain - Where to use
This professional wood stain can only be applied over new or newly sanded wood surfaces. It can be used to seal and change the look of old furniture, new furniture, hardwood floors, semi solid floors, engineered wood floors, handles, frames, etc. One coat of Junckers Anthracite Grey Wood Stain will create a dark grey-stone finish on brighter types of wood. One 1 coat of Junckers Anthracite Grey Wood Stain will create a very dark finish on darker types of wood surfaces, like oak or walnut. You can apply one coat or two coats, depending on the level of richness you plan to achieve. To be sealed with any of the water based or solvent based lacquers from Junckers. If you are planning to use a different brand of varnish or lacquer, make sure that you use a two pack water based sealant or a solvent finish. All Junckers wood stains are oil based.
Junckers Anthracite Grey Wood Stain - How to use
Sand the area to remove any pre-existing finishes from the wood. If you are planning to stain small areas or furniture, just use a cloth. Soak the cloth in wood stain and then rub it against the wood fibre until the wood has absorbed it in full. Do not overuse the stain. About 1 hour later the surfaces should be dry. If you are not fully satisfied with the finish, you can apply a second coat. The drying time can vary from day to day and surface to surface. When staining big floor areas you can use a floor buffer and a white pad to stain evenly. The trick is to give the wood enough stain to look cool without overdoing it.
Junckers Anthracite Grey Wood Stain - Advice
Always wear gloves to avoid staining your skin. Avoid splashing the stain over other areas and clean spillages fast. When staining wood floors, use a cloth to stain the areas around the skirting. After the surface is stained, do not walk on it for 1-2 hours. When the surface looks dry, apply two coats of floor lacquer from Junckers with a 2 hour break between coats. Amazing results guaranteed.