Faber Stone Top Protector 500 ML

Faber Stone Top Protector 500 ML

• 100% invisible solvent based worktop sealer and worktop protector 

• It fully penetrates the surface and it does not create an artificial glaze

• The product is food certified and compatible with all stone worktops

• To be applied in a thin coat over unsealed or already sealed surfaces

• It can be applied with a microfiber cloth, a roller or a special applicator

• The product fully seals the surface, waterproofs and stain protects

• It facilitates easy maintenance and it creates a smooth even finish

• It restores stained and damaged surfaces and it repairs imperfections

• One of the most effective and easy to use worktop stain protectors

• Highly appreciated by the professional worktop polishing contractors

• Sold in a bottle of 500 ML that covers about 5 sq meters of worktop

Faber Stone Top Protector 500 ML | Why Use It

The worktop is exposed to a lot of daily use. Being exposed to so much traffic, stains, harsh acids, enzymes, etc. comes at a cost. Whatever sealer was used to initially seal the worktop is likely to give up after a prolonged use. The issue can be easily sorted by topping up the pre-existing finish with one or two coats of the new Faber Stone Top Protector 500 ML. The product dries in a matter of minutes, it dries up streak free and it starts protecting the surface within a few minutes after the initial application. The product will prevent all kinds of acidic and high PH products from penetrating and staining the stone. It can be easily applied by anyone with access to a clean cloth or some kind of varnishing roller.

Faber Stone Top Protector 500 ML | Where To Use

The new Faber Stone Top Protector 500 ML is compatible with all natural stone worktops and also all artificial stone worktops. Not compatible with laminate worktops or wood worktops. It can be used for sealing and protecting indoor worktops and outdoor worktops. Some worktops that were sealed with very high gloss protectors or glazers might not be suitable for recoating with the new Faber Stone Top Protector 500 ML. It works as well with all kinds of commercial worktops and residential worktops.

Faber Stone Top Protector 500 ML | How To Use It

Start by deep cleaning the whole surface to make sure that the worktop is residue free, grease free and dry. After the initial cleaning, allow the worktop to ventilate for a few minutes to make sure that all the water from the pores has fully evaporated. You can use a varnishing roller, a microfiber cleaning cloth or some type of special applicator. Shake the bottle for a few seconds to create a uniform composition and pour some of the product on the worktop. You can use any of the above tools to spread the product evenly. Do not leave allow the product to puddle up on the worktop. The product has to be spread in a thin and even coat all over the surface. Allow it to dry naturally for about 1-2 hours before using the worktop. You can use a clean microfiber cloth to give the surface a light buff before starting to use it. To speed up the drying periods you can use a hair drier.

Faber Stone Top Protector 500 ML | Recommendations

Do not use the new Faber Stone Top Protector 500 ML over dirty or wet surfaces. Do not use the new Faber Stone Top Protector 500 ML as a daily cleaner. Do not apply a new coat of the protector daily. Do not mix up the new Faber Stone Top Protector 500 ML with any similar product from Faber or other brands. Do not use the new Faber Stone Top Protector 500 ML over laminate surfaces or plastic surfaces. Protect all surfaces that do not need sealing and make sure to wear a pair of gloves while using the product.

Faber Stone Top Protector 500 ML