A non yellowing water based floor lacquer compatible with medium/low traffic floors
It can be used to seal and restore wooden floors, furniture, doors, frames, skirting, etc
Great coverage area, very easy to apply, very forgiving when applied, no overlapping
Available in a clear natural finish | covers up to 12 sq meters per 1L | 100% fume free
To be applied over a new or a newly sanded wooden surface | Suitable for overcoating
It can be applied over all kinds of water based primers or other lacquers from Bona
Very easy to abrade and very quick drying times | Suitable for residential | domestic use
Not compatible with oiled based stains or with very high traffic commercial surfaces
To be applied in a 2-3 coats system | 1 primer + 2 coats or lacquer or 3 coats of lacquer
This product is highly popular with the floor sanding and floor refinishing industry
Bona Domo Floor Lacquer | Why Domo
The new Bona Domo Floor Lacquer is a high quality water based floor lacquer suitable for sealing all kinds of low to medium traffic floors | surfaces. The product is very affordable, it provides great protection against daily traffic and staining and it looks amazing. The product can be used by professionals and by DIY users. Its premium coverage area and it`s low cost, makes this product highly attractive.
Bona Domo Floor Lacquer | Where To Use It
Bona manufactures a wide range of water based floor lacquers suitable for low, medium & high traffic areas. The new Bona Domo Floor Lacquer would qualify for the low | medium traffic areas. The product is highly recommended for sealing and protecting bedroom floors, low traffic playrooms & living rooms, all kinds of unsealed wooden frames, doors & furniture, etc. Basically it can be used to waterproof & stain proof all kinds of surfaces. The product is only suitable for indoor use. It can be used on horizontal and vertical surfaces. It can be used on wood surfaces that are exposed to direct sunlight. After it dries, it looks natural and it enhances the fiber of the wood. Do not apply it over oil based wood stains.
Bona Domo Floor Lacquer | How To Use It
The product has to be applied over new or newly sanded surfaces. In some cases, the new Bona Domo Floor Lacquer can be used as an overcoat over pre existing finishes assuming that the surface is in a great condition, dry & slightly abraded.
All pre-existing finishes have to be removed with sandpaper. Follow all the steps and all sanding grits from 40 grit all the way to 100 grit. The surface has to be scratch free, patch free and pretty smooth. Apply 1 coat of primer (whatever colour is required or the natural one), allow 2 hours to dry, abrade lightly with sanding screens grit 150-180, vacuum well and apply the first coat of floor lacquer. The first coat should be dry in about 1-2 hours. Apply the second coat of floor lacquer the same way as the first one and allow 2-4 hours to fully dry before using the surface.
Even new surfaces might require a light sanding to remove imperfections and create an even absorption. If you are planning to overcoat a pre-existing surface, make sure to deep clean the surface, remove all grease, fats, stains, etc. Lightly sand with very fine sanding paper just to create a bit of rough surface so the new lacquer can attach to the old surface.
Do not apply the new Bona Domo Floor Lacquer over oiled surfaces. Do not apply more than 3 coats of floor lacquer to avoid over glazing the surface. Do not apply over oil based stains. Do not use the new Bona Domo Floor Lacquer to seal high traffic commercial floors or sport halls. Do not mix up the product with any other lacquers. Apply thin and even coats of floor lacquer to ensure quick drying results and beautiful finish.